Як до працювати a дерево подрібнювач

Як to operate a wood shredder?

1. The wood shredder should be fixed on the ground and can be fixed with cement.
2. Before the wood shredder works, it is required to carry out a test machine before starting the machine, which is to simply turn the main shaft to see if the bearing is operating normally. Before installation, check the gap between the parts is firm and hether the foundation is stable. it is a waste of materials to to reinstall the wood shredder after finalizing the shape% 3б
3. The pulverizer and motor should be installed on the base made of angle steel.
4. When the wood flour machine starts to operate, pay attention to wheer there are sundries on the the wood hardder machine. When the wood harded, check the/the it is reversed. Put in vawer materials to see if the finished product is up to standard. Wood grinder customers buy After returning home, when installing and testing the machine, try to wait for the previous piece of wood to enter the enter the подача порт до путтінг в секунда шматок оф дерево до уникнення машина заклинювання.
5. The feeding of the wood shredder should be uniform. If there is noise, excessive temperature of the bearing and the body, outward spraying, etc., it should be stopped негайно for inspection and усунення несправностей.
6. The circuit inspection should be done before starting and shutting down the wood crusher to avoid leakage. The length of the wood must be moderate, not too long, preferably under 30 cm, and not too thick. The area around the outlet and inlet should be as spacious as possible to avoid some accidents.
7. Після 300 годин of operation, the підшипник must be cleaned and the engine oil replaced; when installing the engine oil, it is better to fill the gap of 1/3 of the bearing seat, and no more than 1/2. When stopping for a long time, the transmission belt should be removed.
8. The wood shredder stops feeding before shutting down, and after the materials in the standby are removed, cut off the power and stop. Cleaning and maintenance should be carried out after shutdown.
9. The staff should welyly check the materials before the wood crusher works to prevent hard objects uch as metals and stones from enting the crushing room and causeing accidents.
10. Do not change the шків часто to prevent the speed from being too high or too low.